Hello ,
Im planing to build binghams 62 take down recurve bow. 55@28 it requires 8 1/4" wedge ,maybe you know what thikness is the wedge also what mesurement is from but to the place where it goes to 0. Also what thikness of maple laminations you suggest, i would prefer 1 3/4" wide limbs.
Post this in the bowyers section. Someone there can help.
3/8" thick
taper starts 2.25" from butt
.262" at butt of stack(including 2 pcs .040 glass)
2 pcs .040 glass
maple lams:
1- pair .060 x 1.75
1- pair tapers(.002per inch).122(thick end)x 1.75
Hope this helps!!
http://binghamprojects.com/
Look on left under draw weights....
Good luck,have fun!!
I just finished one of the same bows from Binghams and I measured everything for future reference.
The wedge was 3/8" thick and the taper started after 2 1/2" from the butt end.
My laminations were:
0.060 - parrallel lamination
0.125 - butt thickness on 0.002 taper lamination
0.050 - clear fiberglass.
It ended up 70# at 28". So you will want smaller lams. Check out their website for a guide to thickness.
I must have been typing when Kenny posted his response.
1/4" difference on the distance from the butt of the wedge. Hmmmmm.....maybe I measured it wrong????
The pair I measured could have been slightly diff than yours!
If you wrote it down,lets go with yours!!