I bought some screw in adapters for my glue on magnus heads from magnus. The adapters they reccomended are 5/16. After they are installed the end of the broadhead (where the adapter goes in) goes over top of my insert on my 2016 arrow.
It seems ok, but I am not sure.
What do you think? Should I just buy some 11/32 insert adapters and use them or go as I am?
Thanks,
James
You wont have any problems as long as they spin true and are on tight.
what jon said
OK, Thanks. I was worried when the adapter was in about 1/8" from the back of the broadhead.
These inserts were easier to get good alignment/spin on than the few 11/32 I had.