Text only | Text with Images

Trad Gang

Main Boards => PowWow => Topic started by: Zmonster on December 08, 2009, 07:39:00 PM

Title: AD HammerHead lites outside diameter needed
Post by: Zmonster on December 08, 2009, 07:39:00 PM
Can someone with a caliper get me the outside diameter of Arrow Dynamics Hammerhead lites? Im looking to foot mine with some aluminum shaft, and need the measurement.

   Thanks
Title: Re: AD HammerHead lites outside diameter needed
Post by: Ted Fry on December 08, 2009, 08:08:00 PM
2413 easton works well for footing ADs
Title: Re: AD HammerHead lites outside diameter needed
Post by: Zmonster on December 08, 2009, 08:21:00 PM
Ted,

Thanks for the reply. Do you think the outside diameter will be the same for the Hammerheads? I figured they would be a little bigger than the standard AD's. I saw the chart on the "how to" but no mention of the Hammerheads.

Casey
Title: Re: AD HammerHead lites outside diameter needed
Post by: DannyBows on December 09, 2009, 01:43:00 AM
3 Rivers has "Carbon Collars" for the AD's, including the Hammerheads. I'm going to order some to try.
Title: Re: AD HammerHead lites outside diameter needed
Post by: Zmonster on December 09, 2009, 08:55:00 AM
Yup,

I tried them already. Dont really care for them. I figure I could get alot more footing out of a few shafts.

Thanks,
Casey
Title: Re: AD HammerHead lites outside diameter needed
Post by: Ted Fry on December 09, 2009, 02:17:00 PM
The OD of the Hammerhead is .371 apx.  Give or take a bit. The Trad is apx. .350.
The idea behind the Hammerhead was to build up the front with carbon rather than needing a footing, I really doubt that you would need to add anything to the Hammerhead.
Text only | Text with Images