Got my VPA Terminators in the mail today, 200gr screw-in. Love them but when I measured the width they were slightly under 1". Thought they were suppose to be 1 1/8". Anyone else found this to be the case?
How are you measuring them?
It's about the cut, not the diameter.
These are made from 1-1/8" bar stock. The cutting diameter is 1-1/8". The reason you are getting a smaller measurement across two blades is because on a 3 blade broadhead, the blades are 120 degrees appart and not streight accross from each other like a 2 blade broadhead, but yes they are 1-1/8" diameter.
Thanks for the info. My question has been answered.