I have received my Black Widow MA X from the states. I wish to mount my new side mount Thunderhorn Quiver on my recurve. I already have the insert from Roger at Black Widow.
My question is, could anyone give me some info and advice on how to install the side quiver on the riser of my MA Black Widow? I am mainly after some pictures with measurements of the insert location on the riser.
Any pictures would be greatly appreciated. :help:
John
Here are pics. of a PMA II riser on mine the factory installed bushings are 12 1/2" apart. Hope this helps.
(http://i124.photobucket.com/albums/p2/bretto723/100_0177.jpg)
Top of riser
(http://i124.photobucket.com/albums/p2/bretto723/100_0178.jpg)
Bottom of riser
(http://i124.photobucket.com/albums/p2/bretto723/100_0179.jpg)
Good luck
bretto
Brett,
This is exactly what I was after. Thank you very much for the pics and quick response.
Much appreciated
John
Your welcome.
When I did mine I used a required size brad bit and it drilled a perfect hole without chipping edges. I put masking tape over the hole area then drilled thru it.
Danny,
It is a good ideas. Someone also mention a forstner drill as well. I will definatly use masking tape.
Danny, are you able to send me some pics of you bow as well? Brett sent me some pics which realy help. The more pics I get the better.
Ta
John