I`m tring to use my lil shaver on my grizzley`s. I dont know if I am in the right hole on the jig. I have taken alot of the edge off but I still can`t get any kind of edge on the broadhead. :banghead: Has anybody had any luck with the shaver. Any help would be great. I`m not that good with a file. But I might have to try it. Is there a better way of doing this? Thanks Don
Use the upper hole, it will give you about 25 degrees. You're still going to have to take the new bevel all the way to the far side before it will start to get sharp, and with the little piece of 6" file on the shaver, it may take a while. Once you have the burr going over to the flat side, start using very light pressure on the file. Use a separate file to take the burr from the flat side.