Print Page - I Need arrows for my Bear Grizzly, What size?

Title: I Need arrows for my Bear Grizzly, What size?
Post by: david janssen on March 04, 2009, 08:32:00 AM

I have a 45# Bear Grizzly and I draw 26". I would like to shoot 125 gr. stingers with this bow.I only draw 26" I was wondering what size arrows to start out with.

Alluminum:

Carbon:

Thanks for all the help,

David

Title: Re: I Need arrows for my Bear Grizzly, What size?
Post by: shortstroke 91 on March 04, 2009, 08:51:00 AM

I'd try 1916 on aluminum, start @ full length and cut if you can. My grizzly likes gold tip entrada 600 @ 28.5" but I have 225 grains up front to get them to fly right.

Title: Re: I Need arrows for my Bear Grizzly, What size?
Post by: George D. Stout on March 04, 2009, 10:15:00 AM

The 1916 should work fine if you let them 29 inches long. Most carbons will be much too stiff with 125 grain heads unless full length...over 30 inches. I would try 1916 and let them 29" because you are only pulling around 39 or 40 pounds. An 1816 should work at 28".

Title: Re: I Need arrows for my Bear Grizzly, What size?
Post by: david janssen on March 04, 2009, 10:53:00 AM

Thanks for the advice,

David

Title: Re: I Need arrows for my Bear Grizzly, What size?
Post by: Shawn Leonard on March 04, 2009, 08:20:00 PM

GT Entrada with 125 grain point cut to 29"s should fly well as you are only pulling 39#s or so, ya may even have to shoot a bit more point weight. 1816 if ya can find them cut to 28 or 29"s. Shawn

Title: Re: I Need arrows for my Bear Grizzly, What size?
Post by: jacobsladder on March 04, 2009, 08:27:00 PM

carbon express terminator jrs..they are .628 spine ....come 28" long and are a good little arrow...you'll only be shooting around 400 grains with 175 up front......

Trad Gang

Main Boards => PowWow => Topic started by: david janssen on March 04, 2009, 08:32:00 AM