I'm probably going to be ordering a doz. CX heritage shafts and I'd like to ask a couple questions:
1. I have a Bitz and enjoy fletching my own arrows, but for the money I usually have them MTO from an online dealer (not a sponsor). Is there a sponsor who offers them this way? I'd gladly order from a TG sponsor, if possible.
2. Is there a certain size onestringer wrap that fits these dia. arrows?
3. Is it easier or the same to re-fletch when wraps are being utilized (I use bohning tape)?
I LOVE the look of arrows without wraps, but if it aids in re-fletching, I'll go that route.
4. If there is a sponsor who offers this service, do they also carry the full line of onestringer wraps?
Thanks, guys.
Jeff
Jeff check out Paul from Badger Arrow! Top notch guy!
I like to use wraps for carbons,it makes it a whole lot easier to redo without having to scrape the carbon shaft with a knife,They are easy to gouge,most likely will weaken the shaft there if you cut to deep.Wraps are easliy removed with a hair dryer or some hot water or steam.On a 5/16 carbon like CE I like 1&1/8" wide,I like just alittle overlap.A 1" wrap will usally cover but barely any overlap.I like 1" for Axis/MFX.
Check out
http://www.braveheartarchery.us/
CX Heritage
90's and 150's 1" wide
250 and 250's 1 1/8" wide
Scott