I have been thinking about buying a new set of A&H limbs and building a custom riser for it. I want a riser with a custom designed grip. Has anyone done this? Does anyone know the degree angle of the limbs/riser? How about the limb bold and pin placement setup? Is it the same as most other setups?
Don't know the limb bed angle. The limbs are fastened with one through bolt and two pins. The tolerances on these are very close/tight. Would be very difficult to match without their jig. They may be willing to modify their riser design to meet your needs, or you could modify it yourself after the fact. Why not give them a call.