Text only | Text with Images

Trad Gang

Main Boards => PowWow => Topic started by: Bob Palmer on September 06, 2008, 05:57:00 PM

Title: Beemans HITs in a Selway Quiver?
Post by: Bob Palmer on September 06, 2008, 05:57:00 PM
I have an older Selway quiver not slotted for the small diameter Beeman arrows...how do I stop the rattling??
Title: Re: Beemans HITs in a Selway Quiver?
Post by: LazerRay on September 06, 2008, 06:21:00 PM
(http://ns1.bowsite.org/blackwidow/images/accessorie/499_ArrGripBands.jpg)

This is what you need
Title: Re: Beemans HITs in a Selway Quiver?
Post by: LazerRay on September 06, 2008, 06:21:00 PM
You can try one per arrow or two
Title: Re: Beemans HITs in a Selway Quiver?
Post by: Bob Palmer on September 06, 2008, 06:27:00 PM
Thanks Ray! What are they....where do I get them?
Title: Re: Beemans HITs in a Selway Quiver?
Post by: LazerRay on September 06, 2008, 07:12:00 PM
Black Widow bows dot com
Title: Re: Beemans HITs in a Selway Quiver?
Post by: Bob Palmer on September 06, 2008, 07:15:00 PM
Thanks!!
Title: Re: Beemans HITs in a Selway Quiver?
Post by: JRY309 on September 06, 2008, 10:28:00 PM
You can also get a replacement gripper for Selway quivers at 3Rivers and Kustom King that grips smaller diameter carbons.
Title: Re: Beemans HITs in a Selway Quiver?
Post by: Avalanche123 on September 06, 2008, 11:45:00 PM
I tried this and it worked. I took the rubber out of the quiver (it does slide out) and boiled it in hot water for about 10min. This caused the hole to become smaller and it worked really well.

Good luck with this.
Title: Re: Beemans HITs in a Selway Quiver?
Post by: Steve O on September 08, 2008, 10:47:00 PM
Bob,

I just wrap some rubber bands around the grippers so the arrow gets pushed a little towards the opening to keep it held tight.  Works for any quiver not made for the skinny shafts.
Text only | Text with Images