Print Page - 3 rivers tapering block mounting

Title: 3 rivers tapering block mounting
Post by: flint kemper on May 05, 2008, 09:37:00 PM

Ok, let's see how everyone has there block mounted to there disc sander. I have mine clamped on but the clamp is in the way. Thanks for replies. Flint

Title: Re: 3 rivers tapering block mounting
Post by: Marvin M. on May 06, 2008, 09:08:00 AM

I just bought one myself. Haven't mounted it yet but was planning on using some "C" Clamps and putting the screw part underneath to keep it lower profile on the top.

I'll be watching to see what everyone else does.

Marvin

Title: Re: 3 rivers tapering block mounting
Post by: tenbrook on May 06, 2008, 10:11:00 AM

I am interested in this also. Throwing the tru-center taper tool in the trash!!!!!

Title: Re: 3 rivers tapering block mounting
Post by: Rich LaBombard on May 09, 2008, 09:57:00 AM

ttt

Title: Re: 3 rivers tapering block mounting
Post by: onemississipp on May 09, 2008, 11:43:00 AM

Here are a couple links not the 3 rivers but should get some ideas

http://tradgang.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=1;t=054414

http://tradgang.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=1;t=039867

Trad Gang

Main Boards => PowWow => Topic started by: flint kemper on May 05, 2008, 09:37:00 PM