Trad Gang

Main Boards => PowWow => Topic started by: rainman on September 13, 2020, 04:24:33 PM

Title: glue for woody weights
Post by: rainman on September 13, 2020, 04:24:33 PM

What glue does everyone use to glue the broadheads to the Woody Weights?  I get ferrul tite for the WW to the shaft just wondering if that will work for metal to metal.

Title: Re: glue for woody weights
Post by: M60gunner on September 13, 2020, 05:25:32 PM

It should work. All we used for ever gluing inserts into aluminum shafts. Also for gluing glue on BH’s to metal inserts. Only issue Ferrel Tite had was becoming brittle after a couple years.

Title: Re: glue for woody weights
Post by: rainman on September 13, 2020, 06:08:36 PM

Thanks

Title: Re: glue for woody weights
Post by: Phrogdrvr on September 13, 2020, 08:20:13 PM

I have had good luck with Ferrel Tite for the WW to shaft, then two part devcon epoxy for the head to WW.

Title: Re: glue for woody weights
Post by: gordydog on September 14, 2020, 08:28:41 PM

I use Kimsha, it doesn't become brittle.

Title: Re: glue for woody weights
Post by: NY Yankee on September 15, 2020, 09:32:43 AM

I ran out of Ferrule -Tite one day and went to the hardware store. Found a bag of Gorilla Glue glue sticks for glue guns. I use it the same way as Ferrule-Tite and it works great. Ill never have to buy Ferrule-Tite again. It melts at a low heat and hardens quickly to a firm, tough, rubbery consistency. Not flexing but not hard either.

Title: Re: glue for woody weights
Post by: rainman on September 16, 2020, 01:27:01 AM

James I will try that when my ferrule tite runs out.  That is what I used and it worked great so far.

Semper Fi
Dan