Trad Gang
Main Boards => PowWow => Topic started by: Porkchop1 on February 07, 2019, 01:37:50 PM
-
Where can I find a DIY for building a hard travel case for my longbow and for my 62" recurve?
-
4" schedule 40 PVC pipe with one fixed end cap and a screw on cap for the other end. This is what I used to go to Colorado both times. I mailed my bows and arrows out 2 weeks ahead of time but the PVC pipe could go on an airplane too.
-
Did you pad the tube and caps? If so how did you do it? Rubber insulation sheets?
-
Get the pool noodles from the dollar store for inside the pipe.
-
I'll be following this thread since I've been looking for something like that as well. Has anyone been able to make a case for a longbow that has a quiver on it? I would make a pvc case for my longbow but with my selway on I don't think it would fit.
-
I used foam in the top and bottom and bubble wrap around the bows.
-
I'll be following this thread since I've been looking for something like that as well. Has anyone been able to make a case for a longbow that has a quiver on it? I would make a pvc case for my longbow but with my selway on I don't think it would fit.
Trenton - I did one for my longbow w selway on it when I hunted CO and had to have bow in case on 4 wheeler. 4" PVC and then cut out a gap just big enough for the selway to fit and cut this about 3/4 of the way down the PVC. So when you put it in the bow is inside the PVC and the quiver is on the outside. I had a fixed cap for the front and a twist on cap for the back but didn't bother to put the back cap on as once it's in there it wasent coming out. Hope this makes sense.
Tim B