Trad Gang

Main Boards => The Bowyer's Bench => Topic started by: Bvas on November 20, 2018, 06:33:40 PM

Title: Blending TBird
Post by: Bvas on November 20, 2018, 06:33:40 PM

Long story short.....my bow took a bad tumble, very bad tumble. Of course, the edge of the limbs took the brunt of the blow. I want to sand the edges in several spots to make sure I don’t lift a glass splinter.
Question is, how well does Tbird blend?  Or should I just throw some rattle can finish on it to get thru hunting season and do a complete refinish later?

Title: Re: Blending TBird
Post by: Crooked Stic on November 20, 2018, 11:11:08 PM

If there is a lot of sanding I would patch it for now and refinish later.

Title: Re: Blending TBird
Post by: Roy from Pa on November 21, 2018, 05:03:44 AM

How about camo duct tape?

Title: Re: Blending TBird
Post by: Bow man on November 21, 2018, 06:05:11 AM

Don't use the Rattle can. Just give it a lite sand until areas are where you want it then spray a coat on it. This time of the year with low humidity and furnaces running and with just one coat you will be ready to go in 3 days

Title: Re: Blending TBird
Post by: Bvas on November 21, 2018, 10:01:07 AM

Thanks Dave.

And no thanks Roy.