Trad Gang

Main Boards => PowWow => Topic started by: Markp on September 01, 2018, 10:09:39 PM

Title: Anyone else shoot mulefat shafts?
Post by: Markp on September 01, 2018, 10:09:39 PM
In response to Ken B, in the hunting practice thread:

I can make arrows from 450 to 550 grains, with 133 grain Zwickys and now 151 grain Grizzlies ( actual averages, not the advertised).  My bows are ranging from low 40 pounds to mid 50's.  I spine using the nails at 26 inches method.

My present "go to bow" is 44# at the 24.5" draw.  The bow pulled heavier, but stacked, hurt my shoulder on extended sessions.  I brought it down in weight, but still I do better with heavier arrows, at 500 grains, and shooting blunts today, liked blunts at the 550 grains weight.  They seem more forgiving than 500 grains hunting arrows that I had put  target tips on, shooting a portable little target my girl and I took on a hike. 

To get a parallel shaft in the 11/32 diameter, weight goes down.  I want to have a small diameter behind the broadhead, but still want that above 500 grain weight, so I may go longer, again, on shafting length.  I have barrel tapered as well.

Title: Re: Anyone else shoot mulefat shafts?
Post by: WVFarrier on September 02, 2018, 07:07:21 AM
I bought some off another group.  I like them but they didnt hold up very well.  It was my first time using them so i dunno if it was my fault or not