I am about to set up some hunting arrows and will be using a 100 gr. brass glue in/glue on insert. I will use hot melt on the glue on portion so I can tune the broadhead BUT this will require the glue in portion to be fixed and unaffected by the heat (unless I am missing something here). Which glue is recommended for attaching the insert into the shaft itself?
I would consider GoatTuff for both. Strong as all heck but heat reversible. I would install the insert in the shaft first, then mount the bh after it sets (and that is pretty quick).
Think about an ASD so you have a square shaft end to begin with. Costs a few bucks, but a good idea.
ASD?
Arrow squaring device
Thanks