Trad Gang
Main Boards => PowWow => Topic started by: joel0711 on May 18, 2018, 12:37:30 PM
-
Mid 70's bear grizzly 8.25 brace 45# at 28 I pull 27.5 Nock is 1/8 for flipper rest 2
Using SRF sight but not adjusting it or caring where arrows hit target. Groupings only
1816 arrows cut 29"--145grain field point
Feathered arrows hitting together and bare shafts 4 inches right (right handed shooter). According at adcock tuning you want bareshaft mildly weak and a little low,
I can raise nock some to get little lower on bare shafts.
Should I consider this a tuned bow ????? Coming from compounds and x bows and being able to bust arrows at 20 yds with Excalibur x bow I have no standard to judge by.
-
Nope.
Try cutting 1/2 inch off one arrow and see how it groups with fletched shafts.
If still way right, cut off maybe 1/4 inch and try again.
Repeat until no more than 1 inch right.
I would not settle for more than 1 inch right for the bare shaft.
But you only have 1.5 inches of arrow to work with.
-
Roy's got it but I'd suggest that you try 125 grain points before cutting. See what that does to your grouping first.
Arne
-
Good point, Arne.. :thumbsup:
I overlooked the 145 grain point.
-
125 gr helped greatly,may cut 1/4 inch off,I think that will do it for left/right.
started at 1/2 inch nock point,bareshaft hit low,went to 3/8,hit low,then 1/8,low again. Went the other way after 0 but still low bareshaft all the way to 7/8 inch,still low....... Any ideas why bare arrow would come off low on flipper rest 2 at all nock settings??? Or better off going back to leather rest and plate? THANKS for the assist
-
leave them 29" with the 125 grain pts. run the string nock 3/8 to 7/16 and just shoot if for several days. occasionally throw in a bareshaft, just to see.
I suspect a form issue, anchor/release. having any tender pressure points on the fingers?
check your arrow nocks arent to tight
Rusty
-
Rusty has a good point.
Just shoot the fletched shafts for a week or two.
A video of you shooting would help.