Post by: mlsthmpsn on April 17, 2018, 04:32:38 PM
[ You are not allowed to view attachments ]
[ You are not allowed to view attachments ]
I got the limbs down closer to final widths, and the riser worked out a fair bit. Down to 57.5# now, with a bit of shaping and rounding left to go.
[ You are not allowed to view attachments ]
[ You are not allowed to view attachments ]
[ You are not allowed to view attachments ]
[ You are not allowed to view attachments ]
I did some roughing out on the tip overlays quick this morning but didn't think to take any pics of that.
Should have some more done tonight and will take some more images for you guys.
Post by: Roy from Pa on April 17, 2018, 04:41:48 PM
Post by: kennym on April 17, 2018, 05:01:33 PM
Post by: Forwardhandle on April 17, 2018, 05:05:27 PM
Post by: mlsthmpsn on April 17, 2018, 10:49:49 PM
I like taking pictures of these because you can compare them easily... See just the slightest difference I the first two? (that I hadn't noticed until the first picture was taken)
Gotta bit more to take off the top to even them out, the bunch more to get them pared down.
Post by: yimbow on April 18, 2018, 02:14:20 PM
Post by: jsweka on April 18, 2018, 07:57:13 PM
If you want to get it down to your target of 55#, I think you'd have no problem getting there by just rounding the edges of the limb good.