Trad Gang
Main Boards => The Bowyer's Bench => Topic started by: arachnid on January 03, 2018, 01:40:00 PM
-
Hi Guys.
a few questions about EA40 glue and glue up process:
1) Does anyone here heat the glue before glue up? If so- How long? Befor/after mixing parts A and B? what`s the benefit of worming the glue up?
2) Does the glue count at the total stack? I`ve read on the Bowywer`s Corner Facebook pagethat some guy wrote that every glue line count as 0.003" in the total stack, but I`ve neve saw nor heard of such a thing in other places.
3) One of the guys here wrote to me that he spreads a thin layer on the lam, wait a minute for the glue to soak and do it again for 2-3 times before spreading the final, thicker, layer of glue. Anyone else does it that way? I`ve done it on my last bow and it works great but it uses up a lot of glue.
Thanks
Dor
-
1. No
2. No
3. No
-
Warming a little helps it spread better but to much and your working time diminishes,unless its cold when gluing its not necessary, room temp. is fine. Make sure both surfaces are wet and you should be fine, to much makes everything a bit slippery and is not needed. Glue does count on stack but no real concern unless you have a lot of lams, then to many glue lines will effect performance.
-
1. Only if my glue is cold. lol Warm parts separate before mixing. Warm glue has a thinner consistency and easier to spread. But if you get it too warm, it will set quickly.
2. No
3. I let the wood dictate if it needs a second layer. I check by using light reflection. Add glue until all the surfaces have a wet sheen with no dry spots.
-
What Bvas said.
A few days ago I measured out a small amount of Smooth On for a project and noticed it was cold/stiff. The heater was running so I held the container up to it for about 30 seconds, and that was enough to make a big difference in its viscocity.
I heated it up too much once for a bow build and it started setting up before I could get the bow together. I won't do that again.