Trad Gang
Main Boards => The Bowyer's Bench => Topic started by: Lee Lobbestael on July 28, 2017, 04:08:00 PM
-
I know this question has come up before, but I saw that some of you guys use super glue for tip overlays. Have you had any failures with this? It seems a quicker less messy way of putting on tip overlays and I could hold them where I need them easier than smooth on without any slipping around.
-
I use gel super glue on overlays for my bamboo backed bows. No failures so far.
Dave.
-
All the time, just started using the gorilla super glue with blue lid. I think it is even better than what I used before!
-
Only problem I've had with it is doing a black g10 overlay onto black glass. Never could get that glue line to go away when I did my fades! Lol
-
the only tip I ever had fail was put on with epoxy
-
Mike, me too. But it was antler and when they came off, looked like a starved glue joint.
-
Blue cap Gorilla. Smooth on will give better transition I think on the glass.
-
Originally posted by Crittergetter:
Only problem I've had with it is doing a black g10 overlay onto black glass. Never could get that glue line to go away when I did my fades! Lol
x2
In the long run I think smooth-on is the best way.
-
[
-
I agree. EA40 gives a better blend when fading from overlay into back lam.
Superglue is quick though!
-
All I have ever used has been smooth on. I taper the end of the over lay first, that points inward towards the riser, to a razor edge. After the overlay has been clamped down, I wipe the excess glue off the back joint with a damp cloth soaked with denatured alcohol. Hardly any sanding is needed for a smooth transition onto the limb..
-
Roy I believe pre shaping to almost where you want it is the key to good blend with either glue you use.
-
On the last set of limbs, I used a junk limb off the same form and put plastic wrap on it and CA glued the 2 pcs of phenolic together using it as a form(could have used the bow form but this was handy).
Then ground the end and put on the limb with gorilla blue top.
Won't ever do it any other way!! :thumbsup:
-
Yupper stic..
McKenzie, didn't happen wif out pichers.
-
I've had no luck getting the white color of the CA to go away, I stick to smooth on..although I haven't seen failures with either. If your overlay is pre shaped and requires no further sanding CA is fine if you wipe it off. That's just what I've seen. A buddy uses kind of a chevron tip overlay and CA works fine, no sanding necessary.