Trad Gang

Main Boards => The Bowyer's Bench => Topic started by: Full Draw Too on April 17, 2015, 09:08:00 AM

Title: Quiver Bushings?
Post by: Full Draw Too on April 17, 2015, 09:08:00 AM

Good Morning Bowyer Land..
 I'm getting ready to put those Quiver bushings on the side of my riser. Do you need to drill and tap a hole for these little guys?and then do you epoxy them in? any help would be appreciated.I think these are the 10/24 style from Binghams..Thanks Guys! I'll wait to hear back from you all...Pat

Acts 4:12

Title: Re: Quiver Bushings?
Post by: Roy from Pa on April 17, 2015, 09:47:00 AM

If they have male threads that screw into the riser, then yes drill and tap it and apply epoxy to the threads would be my guess.. I have never tapped wood but I believe there are special wood taps. But a regular metal tap might suffice for only a couple holes.

Title: Re: Quiver Bushings?
Post by: JamesV on April 17, 2015, 11:05:00 AM

The brass bushings (made by Martin)I install from 3 Rivers don't require tapping the hole. Follow the easy instructions and you will be good. I did put a dab of epoxy on them before installing but the instructions says it is not necessary.

James