I am attaching a picture of my Big East bow. The bow has a very shiny high gloss finish. This past hunting season I put camo tape on the bow so I could hunt with it but I would prefer the finish to be less shiny. I have heard that I could use some fine grain sandpaper on the bow but I am worried that I am going to mess up the bow. If the sandpaper is a good idea what grit sandpaper should be used. Does anyone have any other suggestions? (http://i104.photobucket.com/albums/m174/bohuntr77/BigEastBow2.jpg)
Some guys have said you can knock the shine off with some 0000 steel wool. You could try a small area and see how you like it.
Like Snag says the really fine steel wool will work and you can polish it back up with car polish.
You can also carefully spray some satin finish from a rattle can holding it about two feet away; theat's what I do.
There is also a very fine grinding powder named Rotten Stone. I believe it is a finer version of what the dentist use when polishing teeth.
Put some vegetable oil and powder on a soft cloth. Bue--.
My experience is similar to Bjorn's. You can also wet rub it with rottenstone. Either might work, but as often as not, they just tend to polish the finish that's already there. However, giving it a shot of satin finish after the steel wool or rottenstone puts a nice dull finish on it.
Go to a Hobby Shop and ask for a spray can of Testor's Dullcoat. It is used as a topcoat to give a flat finish to models, you won't need to scar up your factory finish, and if you want to restore your bow to original specs, it should be easy to remove.
Application of Butcher's Wax, or other bowling alley-type wax will do the job if you do not polish it. And you have done nothing to your bow that cannot be undone.
steel wool works just fine ....... if you want a high gloss back on the bow later it can ALWAYS be buffed to a very hi gloss ............ much like a car finish ......... they sand with very fine sandapaper which takes out any small imperfections and then buff it out to a hi shine ................ In fact if you purchased a custom bow with a glossy finish it was probably done exactly that way ............. it is rare that you can spray on a finish and not need to sand and buff .
you do want to use caution and take great care not to go thru the finish especially on the sharp corners and edges .............. but with most finishes it is unlikely to go thru with fine steel wool
you could use very very fine automotive sandpaper of say 1200 or 2000 grit. It'll be fine enough not to take to much off and do what you want.
I like shiny bows! Wish I had something to trade ya LOL!
Rub the bow down with some automotive paste wax, like Turtlewax, but don't rub it in. The wax will dry to a dull powdery finish. It protects the bow from the elements as well. When the hunt is over and it's time to hang the bow back on the wall a buff with a cloth will restore the original glossy finish. Works the same way as the butcher's wax mentioned by Naphtali above...
JIM
Crecy, Poitiers, Agincourt
What Naphtali said, Just wax it with a good automotive or paste floor wax and don't buff it, till your done hunting.. If the corners get rubbed off while hunting,, Give them another shot.
I once used 4-0 steel wool and olive oil on a shiney gun stock and it was very satisfactory. The oil lubricates as you go then wipe it off. I never tried to get the shine back as I prefer a satin finish. I think the wax Idea is a good one as others have stated.
I also use dulcote, easy on and easy off if ya deciede to remove it, comes in a small spray can, will not harm your factory finish excellent stuff!!
A quick spray of satin poly will cut the shine if it is compatible with the original finish. Pat