Trad Gang
Main Boards => Hunting Knives and Crafters => Topic started by: gudspelr on May 31, 2011, 05:46:00 PM
-
In an effort to make better knives, I'm trying to get a more consistent process down with each blade. I was wondering when you guys that forge your blades do your normalizing/thermal cycling (3 reducing heat cycles, not annealing)?
I just forged some blades out and while they're relatively knife-shaped, I'm just not good enough to not have to do some more profiling w/ a grinder, etc. Do you normalize after that, or do you wait until you've already put in your bevels, etc.? Are there specific things to be gained if I did it just after they were profiled and before I file in the bevels? I think I've heard of some folks doing all the work til the blade's finished, then normalizing right before quenching?
Thanks for your thoughts.
Jeremy
-
I have a habit of normailing both after the forging and after the rough grinding just prior to the quench. I feel like work induced stress is lessened as well as grain is reduced just before quench.
-
Thanks Lin. Out of curiosity how much work on the blade do you have after the quench? So far I've been pretty much completing the blade except for sharpening. Haven't figured a way that didn't take forever with files after quench (no grinder yet). Matter of fact not sure how to sharpen the blade without going to a friend's place with a belt grinder....?
Jeremy
-
After the quench, I have to finish grind, roll the edge on it, test for proper heat treat, and hand sand the blade.
You should be able to draw file the hardened area if you hold the file correctly. It's tough to start it but once you "break the crust" it will cut. I sometimes use diamond files to rough it up so my regular files will bite. If you cant cut it at all, it's too hard.
-
Thanks Lin
Jeremy