Where can I get a stamp made so that I can put my initials on blades? I tried etching, but didn't like it as much as I thought I would.
Thanks for your input.
Judd
Try www.riversidemachine.net, (http://www.riversidemachine.net,) I think they make them. I bought mine in cal.
If you go with a stamp you may want to consider bulding a press. Pretty simple machine with a 2 ton hydro jack. If you do not get your 1st hammer strike perfect the stamp is tough to get right. Do a little Bing or Google search. There are a few out there making them.
Bob Urban
This is my press, Idea from Karls press
http://emob663.photobucket.com/albums/uu351/danafoursuns/100_0244.jpg
hope the picture shows up
Dana
Thanks for the info.
Judd
I got mine from a place called buckeye engraving and I love it. http://steelhandstamps.com/
I just sent a drawing with the deminsions and they sent me a qoute,I received the stamp in about 3 or 4 weeks.
(http://i292.photobucket.com/albums/mm22/oldpaths/th_100_0308.jpg) (http://s292.photobucket.com/albums/mm22/oldpaths/?action=view¤t=100_0308.jpg)
(http://i292.photobucket.com/albums/mm22/oldpaths/th_100_0265.jpg) (http://s292.photobucket.com/albums/mm22/oldpaths/?action=view¤t=100_0265.jpg)
I just got one made from http://www.infinitystamps.com/
They do nice work, and it took about 3 weeks.
I 2nd OldPaths recommendation of Buckeye Engraving. My stamp is several yrs old, not showing signs of wear, and their prices are very good. Dan
Thanks again for the info.
Judd