Trad Gang

Main Boards => Hunting Knives and Crafters => Topic started by: Steve Nuckels on October 20, 2009, 07:37:00 PM

Title: Will this work?
Post by: Steve Nuckels on October 20, 2009, 07:37:00 PM

I have a piece of steel that has been laying around my garage it's 12 x 11 x 2 1/4 inches and weighs 80 lbs.  

Will this work as an anvil of sorts? If so I would build a solid lumber stand.  Would it work best standing on edge like pictured or flat with the large surface up?

I do have an anvil but the surface is not true.

Thanks Steve

   (http://i442.photobucket.com/albums/qq143/Tillerboy_bucket/FranksKnife005.jpg)

Title: Re: Will this work?
Post by: beaver#1 on October 20, 2009, 09:26:00 PM

i would leave it on end like it is.

Title: Re: Will this work?
Post by: Lin Rhea on October 22, 2009, 08:25:00 AM

Yes. Even if it's mild steel, the surface will work harden to an extent over time. I agree with Dustin, end up. Lin

Title: Re: Will this work?
Post by: SoNevada Archer on October 22, 2009, 04:10:00 PM

Agreed! End up!
Just don't hit the edge & that steel should be fine.

Title: Re: Will this work?
Post by: Steve Nuckels on October 22, 2009, 10:09:00 PM

Thanks for confirming my theory, I already have a design for the base!

Steve
------------
IN GOD WE TRUST

Title: Re: Will this work?
Post by: Lamey on October 23, 2009, 09:53:00 PM

Steve, that will work just fine.   You will occasionally see "cutlers" anvils here and there,  they were just square pieces of steel, no horn, no tail, no hardy etc...  and they work great.  I have a 5 x 5 x 12" anvil that I use alot.   In some ways if you are forging blades the "square" anvils work better as you can get good hammer clearance by working each "end" of the anvil face.  

One thing I would suggest is once you figure out how you are going to set it up,  dress/radius the edges real good.   Its also a bit tricky to fabricate a base that wont/dont want to move under heavy hammering.  If you make up a wood base, which is easy to do with 2 x 6 & 2 x 12's,  put a thin peice of rubber or carpet between the concrete and wood,  it helps alot.  You would think there would be alot of energy loss,  but there isnt, not in my exeperience anyway.

Good luck with it,  post a follow up when you build your base.