Trad Gang
Main Boards => Hunting Knives and Crafters => Topic started by: StephenR on December 09, 2008, 12:19:00 PM
-
im trying to make my first two knives for Chistmas presents and i would like to add about an inch of file work to the blades for a better grip when skinning. Can i do this to a damascus blade thats already tempered ? are there any tutorials on this subject on here ?
-
If the spine was hardened, the answer is no.
Normally, the filework will be done prior to the etching used to expose the different layers so that they are exposed in the filework as well.
My suggestion would be to leave it alone and not get yourself in trouble!
-
dremel tool and a diamond chainsaw bit.<><
-
and dont slip!!!!
-
If you've never tried the dremel on the spine of a knive before, you maybe in for a very interesting file pattern :eek: I would agree with Karl. Try some practice file work on soft steel first then try it on an anealed blade. Nothing wrong with no file work on your first blades..tippit
-
Yap as much as I hate to admit it.I got into a hurry last week and messed up big time.The dremels fiber cutting wheel broke and skipped across my finished blade.It did plenty of damage too.Take your time and be careful...bowdoc
-
I am a beginner,I tried it at about blade #20.Believe me these guys are telling you right practice on something that's not a gift.
All though may work if you don't mind reginding and re-etching
-
Hey Stephen,
I take it you're talkin' about those 2 you posted the pics of. The guys are right. You can, but you probably shouldn't on a treated Damascus blade.
It's not that hard with practice and Damascus isn't some super steel that you can't grind or work. The real problem is as Karl pointed out. If you file, sand or grind Damascus...the etch goes away. Then it pretty much just looks like any other steel.No pretty graining.
Besides, those are great looking classic designs. They are more commonly done without thumb grip filling than with anyway. Nobody's gonna hold it against ya! ;~)
Spend the extra time on fit and finish of the scales. That's what will be most noticed anyway. That's what separates the good makers from the great.
Just go to Karl's site and check out some of his work. Most of his knives are simple, understated, straight forward pieces. Unless you know enough about knife making to catch all the trick little stuff he is really doing. But you can see the quality in each one.
That's the kind of attention to every little detail of fit and finish that will stand out the most.
-
thanks guys i will try to work on them this weekend.
-
You can find good info on filework on this site. Go down the page to filework. http://gbrannon.bizhat.com/old.htm
Take it slow.
Bob