Wondering if anyone can tell me the thread size on screw in points? I have some aluminum inserts that are bound up and would like to buy a tap to clean out the threads.
Thanks! Mark
8-32
Im Pretty sure that the threads are 8-32
8-32 is the thread size for standard screw in inserts. Hope this helps. You may also see it listed on charts as .164 x 32 This is the outside diameter (.164) of an 8-32 screw.
Yes, 8/32.
Thank You Gentlemen for sharing your knowledge!
The tap thread you are looking for is not 8/32.
It is 8 guage, 32 threads per inch.
Also ask for a bottom tap, not tapered or inter.