Trad Gang
Main Boards => Trad History/Collecting => Topic started by: wasapt on August 06, 2010, 10:35:00 PM
-
I have some green tip limbs that fit on a green stripe riser but won't fit on my B riser. The hole in the limb end that slides into the pocket, doesn't quite line up with the screw head in the riser. Anyone seen this before?
-
Remove the locator screw and first see if the limb will fit nice. They can be shot with out the screw , or you can get a replacement screw and file down the head and see if you can get a fit. Check that the screw is seated all the way down. You may want to try and see if the screw in the green strip wood riser is the same as the one in the mag riser.
-
I hate the green tip limbs. Really bad. I had nothing but trouble with a couple of sets. It seems that when Gainesville start making limbs they lost there touch......My 2 cents...
-
Hi Bill:\\
I got ny first set and will be ordering another shortly. Very smart move..........
-
Paul Shaffer also made limbs for the Bear takedowns. I had as set that I just sold. Really smooth.
I did have the same experiemce. I had two green stripes and two sets of green tip limbs. One riser took both sets of limbs fine, but one would nat accept one of the limb sets. Ity was only on the bottem limb. I forced it 'til is went in and id did fine. It was tight getting it off again, but I did.
-
Bryce- Call me. Grant