Trad Gang

Main Boards => PowWow => Topic started by: futuredoc on November 29, 2007, 01:35:00 PM

Title: chalking a file. . . how and why?
Post by: futuredoc on November 29, 2007, 01:35:00 PM
I just read on the woodsman website that they recc chalking your file before sharpening.  What does this entail, and why do you do it?

thanks,


fd
Title: Re: chalking a file. . . how and why?
Post by: John Nail on November 29, 2007, 01:44:00 PM
I use a hunk of carpenter's chalk, and just rub it on. It helps keep the teeth from clogging.
Title: Re: chalking a file. . . how and why?
Post by: Hot Hap on November 29, 2007, 02:09:00 PM
I believe I would use a file card. I would be afraid of the chalk soaking up the relative humidity out of the air and rusting your file. Hap
Title: Re: chalking a file. . . how and why?
Post by: UKarcher on November 29, 2007, 02:51:00 PM
I've done it for years and like John says it stops the teeth from clogging up, especially when you're working on softer metals like aluminum. I just make sure my file is clean when I've finished working with it.
Title: Re: chalking a file. . . how and why?
Post by: Roadkill on November 29, 2007, 03:19:00 PM
chalk it and use the file card before storing the file.  It does make a difference
Title: Re: chalking a file. . . how and why?
Post by: BobCo 1965 on November 29, 2007, 03:23:00 PM
I usually just used a file brush after every use.
Title: Re: chalking a file. . . how and why?
Post by: Eric Krewson on November 30, 2007, 08:36:00 AM
A little tip, The best file brush you can buy is a 99 cent brass BBQ grill brush from the dollar store. I use a lot of files and found this tip on a flintlock building site.
Title: Re: chalking a file. . . how and why?
Post by: NoCams on November 30, 2007, 09:30:00 AM
Eric is tellin ya right ! I use a small toothbrush type brass brush too. I worked as an aerospace machinist for 12 yrs, used all types of files for those 12 yrs. Not saying I am a expert, just got plenty of callouses from pushing files for a few years.

Keep your file in the best shape by keeping it clean, and rust free. Never use any pressure on the backstroke, or better yet, pick the file up on the backstroke so it does not touch the work. File card bristles are a little too big in diameter to clean some of the smaller finer teeth of smaller files, so the brass brush works better. Try not to touch the teeth of the file with your sweaty hands, will rust it quick. If you are going to store your file for a while, especially in the humid south give it a light coat of WD-40. Next time you get ready to use it, just clean with a little acetone or alcohol, chalk it up and make some filings ! Repeat the WD-40 when finished for the day.

I also keep a 12-14" mill bastard file for Broadheads ONLY in my archery tackle box. I mark the file with a sharpie, side 1 & 2. Side 1 is for hogging down new Wensel Woodsmans till I get all three sides cleaned up and almost shaving sharp. I then flip the file and use side 2 for the finish work. A quick strop on wooden block covered in thick leather and ready for surgery.

nocams