I have been using my new Eco-Dipper to put my polycrylic coating on a couple of arrow shafts. I'm new to this. Brand new. First arrows new.
:)
The layer that the dripper puts on the arrow is very thin. I have multiple coats on (5-7) and the shafts have product on them but they are nowhere near as smooth and protected as my other wooden shafts. Can the dipper be modified to put a thicker coating on?
Thanks gents,
Mark
I'm not familiar with that dipper, but if it uses a gasket then the gasket hole is too tight. Run an unfinished shaft (wood) through it to cause a little wear/break in.
I tried it with paints and did not care for it at all.