Does anyone have a 50 gr brass insert for a CE 90. They are 9/32" diameter
Check with the nocking point Tom if they make them Terry will have them or at least be able to tell you where to get them.
Would the brass inserts for a beman centershot fit them ?
The Centershot brass inserts are pretty close but alittle loose.What I did on my CE 90 was to take a standard 5/16" 50 gr. brass insert and spin file it to fit.I chucked up a blunt in my drill and put on the brass insert,And spin and filed to fit,a 50 gr. insert would weigh around 42 grs. when done.I would also file the end to taper down from the 5/16" end to fit the shaft so it would not have a lip.That would make for an easier target removal with a taper.I remember when John owned Sipsey and CE 90's first came out he offered some 100 gr. inserts that were machined down to fit CE 90 and they came out to about 88 grs..
There are creative alternatives as mentioned, but as far as an insert factory tailored to fit them I don't know about one.
I have also used the PDP weighted insert system in the ACC 3.49 size on the smaller CE shafts, but they are a bit undersize so a good glue bond is essential.
JRY309, yeah I have done that also but just wondering if something has changed. Thanks guys.
KentuckyTJ,I haven't seen anything for the CE 90's.I tried some on my H-size Centershot brass inserts,they slide in easily but not as tight as I would like so I just made mine my own.